Difference between revisions of "Arrow Head x Length / Width"
From SAP Enable Now Wiki
| Line 1: | Line 1: | ||
==Scope== | ==Scope== | ||
| − | * '''[[Simulation]]''' content object > '''[[Arrow (Page macro)|Arrow]]''' macro > '''Arrow Head 1: Length''' | + | * '''[[Simulation]]''' content object > '''[[Arrow (Page macro)|Arrow]]''' macro > '''Arrow Head 1: Length''' property |
| − | * '''[[Simulation]]''' content object > '''[[Arrow (Page macro)|Arrow]]''' macro > '''Arrow Head 1: Width''' | + | * '''[[Simulation]]''' content object > '''[[Arrow (Page macro)|Arrow]]''' macro > '''Arrow Head 1: Width''' property |
| − | * '''[[Simulation]]''' content object > '''[[Arrow (Page macro)|Arrow]]''' macro > '''Arrow Head 2: Length''' | + | * '''[[Simulation]]''' content object > '''[[Arrow (Page macro)|Arrow]]''' macro > '''Arrow Head 2: Length''' property |
| − | * '''[[Simulation]]''' content object > '''[[Arrow (Page macro)|Arrow]]''' macro > '''Arrow Head 2: Width''' | + | * '''[[Simulation]]''' content object > '''[[Arrow (Page macro)|Arrow]]''' macro > '''Arrow Head 2: Width''' property |
==Purpose== | ==Purpose== | ||
| Line 9: | Line 9: | ||
[[File:Arrow Head.png|center|How the Arrow Head Length and Width are calculated]] | [[File:Arrow Head.png|center|How the Arrow Head Length and Width are calculated]] | ||
Note that for the '''Circle''' arrow heads, only the '''Length''' property is taken into account, and this applies to both dimensions. | Note that for the '''Circle''' arrow heads, only the '''Length''' property is taken into account, and this applies to both dimensions. | ||
| + | |||
| + | [[Category:Property]] | ||
Revision as of 05:35, 16 September 2019
Scope
- Simulation content object > Arrow macro > Arrow Head 1: Length property
- Simulation content object > Arrow macro > Arrow Head 1: Width property
- Simulation content object > Arrow macro > Arrow Head 2: Length property
- Simulation content object > Arrow macro > Arrow Head 2: Width property
Purpose
The Arrow Head x Length and Arrow Head x Width properties specify the size of the arrow heads on the ends of an arrow 'line'. Arrow 1 is on the 'start' end of the line, and Arrow 2 is on the 'end' end of the line. The Length specifies the size of the arrow as measured along the 'shaft' of the arrow, and the Width specifies size of the arrow head as measured out from the shaft. This is better understood from the following illustration:
Note that for the Circle arrow heads, only the Length property is taken into account, and this applies to both dimensions.
